This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
recap [2016/12/23 13:57] mcmaster |
recap [2016/12/23 13:58] (current) mcmaster |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| Some options: | Some options: | ||
| - | * Tape over cavity: current standard practice. Use Kapton | + | * Tape over cavity: current standard practice. Use Kapton. When wrapped fully around is very strong |
| - | * Slide coverglass glued to top: probably a good long term solution | + | * Slide coverglass glued to top: probably a good long term solution. CA glue allows later removal |
| * Nail polish: dries slowly. Would need to be applied in thin layers. Otherwise, think its pretty inert? | * Nail polish: dries slowly. Would need to be applied in thin layers. Otherwise, think its pretty inert? | ||
| * Hot glue: CTE might destroy bond wires | * Hot glue: CTE might destroy bond wires | ||